Herunterladen Inhalt Inhalt Diese Seite drucken

Parkside PISG 80 A2 Originalbetriebsanleitung Seite 40

Inverter-schweissgerät
Vorschau ausblenden Andere Handbücher für PISG 80 A2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Safety instructions
Safety instructions
If electrical contact voltage occurs,
immediately switch the equipment
off and have it inspected by an
electrically skilled person.
Always ensure good electrical
contacts on the welding current
end.
Always wear insulating gloves on
both hands whilst welding. These
will protect from electric shock
(no-load voltage of the welding
current), from hazardous rays
(heat and UV rays) and glowing
metal and weld splashes.
Wear solid, insulating shoes. The
shoes should also insulate when
exposed to moisture. Low shoes
are not suitable, as glowing metal
drops falling could cause burns.
Wear suitable protective clothing,
no synthetic garments.
Do not look into the arc with
unprotected eyes, only use a
welding shield with approved
protective glass per DIN. In
addition to light- and heat rays
which could result in blinding or
burns, the arc also emits UV rays.
Without adequate protection,
this invisible ultraviolet radiation
causes very painful conjunctivitis
which is only noticed a few hours
later. UV rays further cause burns
40
GB
10 GB/IE/NI
281479_Inverter Schweissgeraet PISG 80 A1_content_GB_IE_NI.indd 10
286508_Inverter Schweissgeraet_PISG 80 A2_Content_LB3.indb 40
similar to a sunburn in unprotected
areas of the body.
Persons near the arc or assistants
must also be informed of the risks
and outfitted with the necessary
protection. If necessary, set up
protective panels.
Ensure an adequate supply of
fresh air whilst welding, particu-
larly in small spaces, as it produces
smoke and harmful gasses.
Do not weld containers in which
gasses, fuels, mineral oils, etc.
were stored - even if emptied a
long time ago - as residue poses
an explosion hazard.
Special regulations apply in rooms
posing fire- and explosion hazards.
Welded joints exposed to great
strain and needing to meet cer-
tain safety requirements must be
made by specially trained and
certified welders. Examples are
pressure vessels, running rails,
tow couplings, etc.
ATTENTION! Always connect
the earth terminal as close as
possible to the point of weld to
provide the shortest possible path
for the welding current from the
electrode to the earth terminal.
Never connect the earth terminal
to the housing of the welding
equipment!
28.12.16 12:22
14.02.18 08:50

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 286508

Inhaltsverzeichnis