Safety Hazards During Arc Welding - Parkside PISG 80 A2 Originalbetriebsanleitung

dangerous, there is a risk of elec-
tric shock.
Do not store or use the equipment
in a moist or wet environment or
in the rain. The Protection Provision
IP21S applies in this respect.
Protect the eyes with the appro-
priate safety glass (DIN Grad
9-10) to be installed in the
included welding shield. Use
gloves and dry protective cloth-
ing free from oil and grease to
protect the skin from ultraviolet
rays and the arc.
welding power source to thaw
pipes.
Remember:
The arc ray can damage the
eyes and cause burns to the skin.
Arc welding produces sparks and
drops of molten metal, the welded
work piece begins to glow and
remains very hot for a relatively
long time. Therefore do not touch
the work piece with bare hands.
Arc welding releases noxious
fumes. Be careful not to inhale
these as best possible.
Protect yourself from the danger-
ous effects of the arc and keep
persons not involved in the work
at least 2 m away from the arc.
281479_Inverter Schweissgeraet PISG 80 A1_content_GB_IE_NI.indd 9
286508_Inverter Schweissgeraet_PISG 80 A2_Content_LB3.indb 39
Do not use the
Arc welding produces a variety of
safety hazards. It is therefore par-
ticularly important for the welder to
observe the following rules to avoid
putting himself and others in danger
and to prevent damage to persons
and the equipment
Safety instructions
Safety instructions
ATTENTION!
Depending on mains conditions
at the connection point, operat-
ing the welding equipment may
interfere with the voltage supply
for other loads. When in doubt,
please contact your power sup-
ply company.
Operating the welding equipment
may interfere with the functional-
ity of other devices, e.g. hearing
aids, pacemakers, etc.
Safety hazards
during arc welding
Only have work to the mains
voltage end, e.g. to cables, plugs,
outlets, etc. performed by a elec-
trically skilled person in accord-
ance with national and local
regulations.
In the event of an accident, im-
mediately disconnect the welding
equipment from the mains voltage.
GB GB/IE/NI 39 9
28.12.16 12:22
14.02.18 08:50