Maintenance; Adjustment Of The Quick Release Fastener; Disposal; Environmental Note - Eufab JAKE Bedienungsanleitung

Maintenance / Disposal / Contact

Maintenance

Before each trip, check the bicycle carrier for wear.
Defective metal parts and tightening straps in particular
must be replaced.
Please refer to our customer service for the replacement
of parts.
Any modification of original parts and materials or the
construction of bicycle carrier can adversely affect its
safety and serviceability.
The steel parts of the bicycle carrier are protected at the
factory against corrosion using a powder coating. If this
paint coating is damaged, please have the damage
repaired professionally as soon as possible.
Under normal conditions, the bicycle carrier only requires
cleaning and is otherwise maintenance-free.

Adjustment of the quick release fastener

Only perform this maintenance operation if the bicycle
carrier cannot be mounted firmly to the trailer coupling, as
described in the chapter "Mounting".
• Remove the bicycle carrier from the trailer coupling as
described in "Dismantling".
• Remove the dust cap.
• Loosen the locking nut slightly, as shown in the
illustration.
• Screw in the setting screw one quarter of a turn.
• Tighten the locking nut.
• Check whether the carrier is now firmly seated on the
trailer coupling as described in "Mounting". If not,
repeat steps described above.
30

Disposal

Environmental note

Local regulations must be observed for the disposal of the
product.
The packaging should also be sorted by type and
disposed of in the relevant collection containers.
Further information is available from your communal
disposal point.

Contact

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
GERMANY
Telefon: +49 (0) 202 - 429283-0
Telefax: +49 (0) 202 - 429283-20
E-mail: info@eal-vertrieb.com