Yamaha mLAN8P Bedienungsanleitung Seite 9

A LEDs
The LED lights up to indicate the status of
the unit as follows:
[LOCK]
The condition in which the mLAN8P receives
word clock from another device correctly is
called "lock." The left LOCK LED indicates
the status of signals input at Digital In. The
right LOCK LED indicates the status of mLAN
signals.
green : Lock
off : Unlock (A cable is not connected or
word clock is not received correctly.)
[DATA]
green : Normal status
red : Sound is interrupted due to con-
nection or removal of a device on
the bus, changes to the connec-
tion, out of word clock sync, etc.
[RT/ERR]
green : The mLAN8P is a "root."
red : An error has occurred.
off : Status other than above.
* This LED is also located on the right end of
the rear panel.
NOTE Refer to "LED/LCD Messages" on page
37 for information on the error indication.
B LCD (Liquid Crystal Display)
The LCD displays various data and informa-
tion.
C INPUT VOLUME
This knob is used to adjust the volume level
of audio signals input from the ANALOG IN
jacks.
D ON/STANDBY, PHONE VOLUME
Press this knob to switch the power on and
standby (off). Turn the knob to adjust the
headphone volume level.
Even when the switch is in the "STANDBY"
position, electricity is still flowing to the
instrument at the minimum level. When
you are not using the mLAN8P for a long
time, make sure you unplug the AC power
adaptor from the wall AC outlet.
Names and Functions
E Mode buttons
These buttons, combined with the channel/
function buttons, are used to select the set-
ting parameters.
F Channel/function buttons
These buttons, combined with the mode but-
tons, are used to select the setting parameters.
[MIDI] mode
[IN] [OUT-A] [OUT-B] : Settings for the connection
destination of the devices con-
nected to the MIDI terminals
[UTILITY] mode
[DIRECT] : Direct out settings
[WCLK] (WORD CLOCK) : Word clock-related settings
[SYSTEM] (SYSTEM) : System settings
[MTER] (METER) : Level meter indications
[Mixer 1] mode
[1] - [8] : Settings for the input channels
of the mixer input section
[Mixer 2] mode
[9] [10] : Settings for the input channels
routed from Digital In.
[11] [12] : Settings for the input channels
routed from A/D In.
[AUX1] [AUX2] :Settings for AUX 1/2
[L] [R] : Settings for the output desti-
nation
G PAGE button
These buttons are used to navigate back and
forth through the parameters.
H +1/ENTER and –1/EXIT buttons
These buttons are used to increment or dec-
rement the parameter value by one. Press
and hold down one of these buttons to
change the value continuously. While the
mLAN8P displays the confirmation dialog for
an edited settings, these buttons are used to
execute (ENTER) or cancel (EXIT) the opera-
tion.
I VALUE dial
This dial is used to increase or decrease a
parameter value continuously. It is useful when
you wish to change a value significantly.
J PHONES jack
Connect a pair of stereo headphones here.
The signals routed to ANALOG OUT 1/L and
2/R are also output here.
9