Yamaha mLAN8P Bedienungsanleitung Seite 21

Input to the mLAN8P
• Input1–8...[MIXER1]
• Input9–12...[MIXER2]
• MIDI Out A/B...[MIDI/UTILITY]
Output to other mLAN devices
• AUX1 (A1), AUX2 (A2), Mix Out L (L), Mix Out R (R)...[MIXER2]
• Digital In L, Digital In R, A/D In L, A/D In R, MIDI In...[MIDI/UTILITY]
2. To set the signal input at the mLAN8P's channel 1 (Input 1), press channel button [1].
NOTE For any cases other than the example described above, usethe appropriate
channel/function buttons, according to the desired input source or output
destination. For more information, refer to the Function Tree table on pages
18 and 19.
3. Press the [ PAGE] button until the Input Device, Input Nickname, or Input Device/Nick-
name page appears.
NOTE The combination of "Vendor (provider)" and "Module (model)" are used to
specify a "Device." (The Vendor name may sometimes be omitted.)
Displaying the Device/Nickname
Press the currently selected mode button repeatedly to switch the display for Device and
Nickname as follows:
• Device/Nickname
• Device
• Nickname
NOTE
To set the output destination (mLAN input plug) for the audio signals input to
the rear panel, use the [
This step is not necessary for MIDI signals.
Connecting I/O signals between mLAN devices
PAGE ] buttons to select the input source.
21