Display Content During Normal Operation; Safety Instructions - eQ-3 MAX! Bedienungsanleitung

2.1 Display content during normal operation

During normal operation, the operating mode, weekday,
setpoint temperature, time, radio-controlled operation and
heating phases are displayed. In the example below, the
MAX! Radiator Thermostat + is in automatic mode (auto),
and the comfort temperature (
weekday displayed is Tuesday (Tu) and the time is 19:07 h.
The antenna symbol ( ) indicates that the connection to
taught-in component has been established. The heating
phases are displayed as bar chart.
The bars for the heating phases in the week pro-
gramme will only be displayed if the saved tempera-
ture is higher than the set-back temperature. Please
see section 14.1 for examples.
The device may only be operated indoors and must
be protected from the effects of damp and dust, as
well as solar or heat radiation. Using this device for
any purpose other than that described in this oper-
ating manual does not fall within the scope of inten-
ded use and shall invalidate any warranty or liability.
This also applies to any conversion or modification
work. This device is intended for private use only.
52

3. Safety instructions

) of 21.0°C is set. The