eQ-3 MAX! Bedienungsanleitung Seite 113

• Once you have fastened the wall bracket for the magnet
(2), insert the magnet.
• Then place the cap on the magnet.
• Once you have fastened the wall bracket for the electro-
nic unit (1), attach the electronic unit.
Now teach in the MAX! window sensor on the MAX!
cube or a MAX! radiator thermostat as described in
section 7 before placing the cap on the electronic
unit.
• Once the MAX! window sensor has been successfully
taught in, complete the mounting procedure by placing
the cap (white and brown caps are supplied with the de-
vice) on the electronic unit.
6. Inserting (replacing) batteries
The window sensor runs on 2 LR03 (micro/AAA) batteries.
• Remove the cover on the electronic unit by pulling it for-
ward and off the device (1). To release the cover, squee-
ze it gently from above and below with your thumb and
index finger (2).
• Carefully lift the release clip (4) from the
side (see graphic p. 22).
• Pull the electronic unit forward (3) and
off the bracket.
• After removing the old batteries, please
wait approximately 60 seconds before
inserting the new ones.
• Insert 2 new LR03 (micro/AAA) batteries
in the battery compartment (making sure
that you insert them the right way round).
21