C) Via Stretch Band; D) Via Car Suction Cup - Conrad 86 05 59 Bedienungsanleitung

c) Mounting the Camera via Stretch Band (17)
• Push the camera into the stretch band holder (17) with the holder until you can hear a click
• Insert the included stretch band or another band (e.g. ski goggles band) into the intended brackets on
the front and rear
• Adjust the band to the correct length
• Attach the band to the helmet or the arm
• Push both pins of the camera holder together slightly to loosen the holder and pull the camera from
the helmet holder
22
d) Assembly of the Camera Car Suction Cup Holder (18)
• For this, loosen the camera holder (13) from the camera (14)
• Screw the suction cup holder (19) to the camera (14)
• Push the suction cup (20) onto a smooth, clean surface (e.g. car windshield or another straight sur-
face)
• Then push the lever (21) down for final attachment; the suction cut attaches itself to the surface
• Use the ball head to adjust the correct camera position
• Fasten the camera by tightening the screws (22)
• Gold the suction cup (20) lever up again to loosen it; loosen the fastening screws (22) and turn the
holder (19) from the camera again (14)
18
19
20
21
45