Technical Data; Before Starting The Equipment; Assembling The Machine - EINHELL 42.506.70 Originalbetriebsanleitung

4. Technical data

Nominal input voltage ....................230V ~ 50 Hz
Power rating .............................................. 350 W
Motor speed ........................................ 1,400 rpm
Output speed ............................. 580 - 2,650 rpm
Speed levels ..................................................... 5
Drill chuck mount ......................................... B 16
Scroll chuck ..................................Ø 1.5 - 13 mm
Max. shaft diameter .................................. 13 mm
Reach .................................................... 104 mm
Drill depth ................................................. 50 mm
Pillar diameter .......................................... 46 mm
Height .................................................... 590 mm
Weight .........................................................16 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level ........................ 62 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 75 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Anl_TC-BD_350_SPK9.indb 19 Anl_TC-BD_350_SPK9.indb 19
GB
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.

5.1 Assembling the machine

•
Position the machine base (1).
•
Fasten mounting flange with pillar (2) using
three screws (3) and washers to drill base (1).
•
Push the drill table (4) with drill table clamp
shaft onto the pillar (2) (Fig. 4). Lock the drill
table into the desired position using the clam-
ping screw (5).
•
Place drill head (6) with V-belt cover (7) and
motor (8) onto the drill pillar and fasten using
the screws (20).
•
Screw the three ball-shaped handles (9) onto
the feeder cross handle.
Note: All bare parts are greased in order to pro-
tect them from corrosion. Before mounting the drill
chuck (10) onto the spindle (11), both parts must
be completely degreased using an environmen-
tally friendly solvent. This ensures optimal trans-
mission of power.
5.2 Installing the machine (Fig. 1)
Before you use the drill for the fi rst time it must be
permanently fi xed in position. Use both mounting
holes (12) in the base plate to do this. Ensure that
the equipment is freely accessible for operation,
adjustment and maintenance.
- 19 -
13.06.2017 13:22:00 13.06.2017 13:22:00