Sony LH51-1T01 Bedienungsanleitung

Display Unit / Anzeigeeinheit
LH51-
Instruction Manual / Bedienungsanleitung
[For the customers in U. S. A.]
WARNING
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the
instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in
a residential area is likely to cause harmful
interference in which case the user will be required to
correct the interference at his own expense.
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
[For the customers in Australia]
Australian EMC Notice
This product complies with the following Australian
EMC standards.
AS/NZS 4252.1 /94 EMC Generic Immunity Part1
AS/NZS 2064 /92 Emission Standard for ISM
Equipment
1T01/ 2T01/ 3T04
[ For EU and EFTA countries ]
CE Notice
Marking by the symbol CE indicates compliance of the
EMC directive and the Low-voltage directive of the
European Community.
meets of exceeds the following technical standards.
EN 55011 Group 1 Class A / 91 :
" L i m i t s a n d m e t h o d s o f m e a s u r e m e n t o f
electromagnetic disturbance characteristics of
industrial, scientific and medical (ISM) radio-frequency
equipment"
EN 61000-3-3 / 95 :
"Limitation of voltage fluctuations and flicker in low-
voltage supply systems for equipment with rated
current ≦ 16 A"
EN 50082-2 / 95 :
"Electromagnetic compatibility - Generic immunity
standard Part 2 : Industrial environment"
EN 61010-1 A1+A2 :
"Safety requirements for electrical equipment for
measurement, control and laboratory use Part 1:
General requirements"
警告
本装置を機械指令 (EN 60204-1) の適合を受ける機器
にご使用の場合は、その規格に適合するように方策
を講じてから、ご使用ください。
Warning
When using this device with equipment governed by
Machine Directives EN 60204-1, measures should be
taken to ensure conformance with those directives.
Warnung
Wenn dieses Gerät mit Ausrüstungsteilen verwendet
wird, die von den Maschinenrichtlinien EN 60204-1
geregelt werden, müssen Maßnahmen ergriffen
werden, um eine Übereinstimmung mit diesen
Normen zu gewährleisten.
Such marking is indicative
1