Original Ancillaries / Accessories; Before First Use; Charging The Battery Pack; Inserting / Removing The Rechargeable Battery Pack Into / From The Device - Parkside PAP 6 A1 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Before first use
without an inserted cartridge. By doing this you
will ensure you device continues to operate
perfectly.
½
Pay attention to the expiry date on the cartridge.
Old or dried-out cartridges can result in over-
loading and damage to the device.
½
Read the information from the cartridge manu-
facturer about use and working temperatures.
By obeying the cartridge manufacturer's instruc-
tions diligently you will avoid damaging the device.
½
Start your work using a low speed setting. This
will avoid overloading the motor and uninten-
tional extrusion of the sealant / adhesive.
½
Switch the device off immediately if you hear
unusual noises from the device. Otherwise you
may damage the device.
½
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.
©
Original ancillaries /
accessories
½
Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an increased
risk of personal injury for you.
©
Before first use
©

Charging the battery pack

½
SHOCK! Always pull out the mains adapter with
mains plug
before cleaning or maintaining the
9
charger or rechargeable battery pack
6
Note! A new battery pack
been in use for an extended period, must be charged
up before the first / renewed usage.
10 GB/IE
RISK OF ELECTRIC
, or one that has not
2
The battery pack
ca. 3-5 charging cycles.
CAUTION! Always pull out the mains plug
before you insert the battery pack into or remove it
from the charger.
½
Never charge the battery pack
ent temperature is less than 10 °C or greater
than 40 °C.
1. Insert the rechargeable battery pack
the charger
2. Insert the mains adapter with mains plug
into the mains socket. The now illuminated red
charge indicator LED
charging process has started. The red charge
indicator LED
as the rechargeable battery pack is completely
charged.
3. The green charging control LED
you that the charging process is complete and
the battery pack
½
Do not charge a rechargeable battery pack
for a second time in close succession. Otherwise
there is the danger that the rechargeable battery
pack will become overcharged and its useful
2
life and that of the charger
Switch the charger
between successive charging processes. To do this,
pull out the mains adapter with mains plug
©
Inserting / removing the
rechargeable battery pack
into / from the device
Inserting the rechargeable battery pack:
Insert the rechargeable battery pack
the device handle until you feel it engage.
Removing the rechargeable battery pack:
Remove the rechargeable battery pack
. pressing the battery pack release button
2
and pulling the rechargeable battery pack
out of the device handle.
attains its full capacity after
2
if the ambi-
2
(see Fig. A).
6
indicates that the
8
ceases to illuminate as soon
8
signals to
7
2 is ready for service.
will be reduced.
6
off for at least 15 minutes
6
into
2
9
2
.
9
into
2
by
2
3
2