Epson TM-L90 Bedienungsanleitung Seite 9

When you install the printer horizontally, attach
the control panel label and position the roll paper
near end sensor as shown in the illustrations. To
move the sensor, follow these steps.
1. Loosen the screw with a coin or similar tool
and turn it at least 3 or 4 times.
2. Push the lever gently as far as it will go.
3. Turn the tab (in the direction of the arrow in the illustration) while
pushing the lever until it clicks into place in hole A.
4. Secure the screw and make sure
the lever moves smoothly.
Note:
To hang the printer on the wall, see the
Wall Hanging Bracket Set Installation
Manual provided with the WH-10 for
instructions.
Installing the Roll Paper
When you use the printer horizontally, peel off the backing sheet of the
paper exit guide and attach it as shown below to prevent cut paper
from falling inside the printer after paper is cut by the autocutter.
Note:
If you use roll paper with a
core that is smaller than the
specifications (inside
diameter of at least 25.4 mm
and outside diameter of at
least 31.4 mm), be sure not
to attach the paper exit
guide. Otherwise a paper
jam might occur.
Be sure to use the roll paper that meets the specifications.
1. Open the roll paper cover, using the cover open lever.
tab
screw
TM-L90 User's Manual 5
English
A
paper
exit
guide