Using The Appliance; Ironing Without Steam - Philips Aquazur HI845 Bedienungsanleitung

ENGLISH
10

Using the appliance

Steam ironing
1 Make sure that there is enough water in the water tank.
2 Put the iron on the rubber mat.
3 Select the recommended ironing temperature (see chapter
'Preparing for use', section 'Setting the temperature').
C
4 Select the appropriate steam setting. Make sure that the steam
setting you select is suitable for the ironing temperature
selected:
- 1 - 2 for moderate steam (temperature settings 2 to 3)
- 3 - 4 for maximum steam (temperature settings 3 to MAX)
The iron will start steaming as soon as the set temperature has been
B
reached.
Just before the water tank is empty, the iron will normally produce a
B
burst of steam and some minor spitting may occur.This is a normal
phenomenon related to the electrical pump.

Ironing without steam

1 Select the recommended ironing temperature (see chapter
'Preparing for use', section 'Setting the temperature').
Do not squeeze the steam trigger.
Features
Spray function
You can use the spray function to remove stubborn creases at any
temperature.
1 Make sure that there is enough water in the water tank.
C
2 Press the spray button several times to moisten the article to
be ironed.
When the internal reservoir is empty, squeeze the steam trigger for
B
about one minute to refill it. Refilling is complete when you see or hear
steam coming out from the steam vents in the soleplate.
C
◗ The internal reservoir must be filled at a temperature setting
between 2 and MAX. It is not possible to fill the internal
reservoir at a temperature setting below 2.