Steam Ironing - Beko SGA7126P Anleitung

3 Operation
4. Place the water reservoir (5) in its place.
– You will hear a click when the water reservoir
fits into its place.
2
click!

3.7 Steam ironing

1. Fill the water reservoir (5) with water (see 3.6).
2. Place the appliance on the steam station
surface (7).
3. Plug in the appliance.
1
– You will hear a beeping sound when the
appliance starts to operate.
– Control panel (10) flashes once and then goes off.
4. Press the on/off button (11).
C
Operation of the pump may make
some noise during the water
drawing process; this is normal.
The appliance starts in Smart-ECO
C
mode in the initial use. This level
offers safe temperature and steam
amount for all the fabrics that can
be ironed.
5. You can set temperature levels other than the
Smart - ECO mode by using the control button
(11) (see 3.4).
10 / EN
A
6. When the symbol of the selected setting flashes
consistently on the display, your appliance is
ready to iron.
A
C
7. When the appliance is ready for steam ironing,
move the iron horizontally on the fabric to be
ironed and press the steam trigger (12). Your
iron will raise steam from its soleplate (8) as
long as you hold the steam trigger pressed.
2
8. When the ironing process is over, press the on/
off button (11) for a few seconds.
– The lights on the control panel will go off.
9. Unplug the appliance and leave it to cool.
WARNING: Your selection should
be suited for the fabric to be ironed.
WARNING: If the symbol on the
display blinks, this means that the
soleplate temperature setting is not
at the desired level.
You can do steam ironing by
using the steam trigger (12) at all
temperature levels except for "•".
Steam Station / User Manual