Electrical Connections; Monitor Lights - Märklin 60832 Bedienungsanleitung

Electrical Connections

The m83 decoder only needs to be connected to the
track current and to the turnouts to be controlled. The
decoder can also be connected to the 66361/66365 swit-
ched mode power pack (only in conjunction with 60822)
(here power is not taken from the track and the power
demanded from the track is thereby less).
The ends of the wires must be stripped and twisted but
not tinned for electrical connections to the decoder and
from turnouts to the decoder. The set screws on the
terminals must be loosened before connecting the ends
of the wires to them.
Several m83/m84 decoders can be plugged together
with the side plug contacts. No extension or connecting
wire may be used for this. All of the decoders plugged
together are supplied with power from the power
connections (power supply or track connections) made
to the first turnout decoder. No other track connections
may be made.

Monitor Lights

• If the m83 is connected correctly, a monitor light will
blink.
• The second monitor light blinks briefly one time when
the decoder is addressed, i.e. when it is switched or
programmed.
• If both monitor lights at the connections blink rapidly, then
the red and the brown wires were mistakenly swapped.
• The monitor lights at the switching outputs display the
current status of the circuit being switched.
Connection for 66361 + 60822
Anschluss für 66361+60822
*
4
0 B
yellow
brown
blue
red
* Not included with the decoder as delivered.
Turnout lanterns for C Track: 74470
Turnout lanterns for K Track: 7547
* * *
3 2 1
17