Werbung
This product, when used in combination with
amplification and/or additional loudspeakers,
may be capable of producing sound levels that
could cause permanent hearing loss.
DO NOT operate at high volume levels or at a
level that is uncomfortable. If you experience
any discomfort or ringing in the ears, or suspect
an hearing loss, you should consult an audiolo-
gist.
To protect your speakers
When choosing a power amplifier to use with your speakers,
make sure that its power output matches the speakers' power
capacity (refer to the Specifications on page 5). Even if the
amplifier's power output is lower than the speakers' PGM (pro-
gram) power capacity, the speakers may be damaged when clip-
ping of a high input signal occurs.
The following may cause damage to speakers:
• Feedback caused when using a microphone.
• Continuous high sound pressure level produced by electronic
instruments.
• Continuous high-power output distorted signals.
• Popping noises caused by turning on equipment, or by con-
necting or disconnecting system components while the ampli-
fier is turned on.
Before Making Connections
I Phone Plug Wiring
Phone plugs for connection to the phone jack inputs should be wired as
shown to the right. Be sure to use proper speaker cable — NOT shielded
instrument or line cable — for all speaker connections.
I Neutrik NL4FC Plug Wiring
If you will be using the Neutrik connectors for speaker input,
wire the plugs as shown to the right. Be sure to use proper
speaker cable — NOT shielded instrument or line cable — for all
speaker connections.
4
Poly Switch
All full-range loudspeakers are fitted with a self-resetting poly
switch that protects the high-frequency driver from damage
caused by excessive power.
If a loudspeaker cabinet loses high-frequency output, immedi-
ately remove power from the unit and wait for two to three min-
utes. They should allow the poly switch to reset. Re-apply power
and check the performance of the high-frequency driver before
continuing with the power reduced to a level that does not cause
the poly switch to interrupt the signal.
• In any system using two or more speakers, be sure to match the
connection polarities of all speakers to the amplifier(s) – e.g.
always connect "+" to "+" and "-" to "-". If the polarities are not
properly matched the speakers will be driven out of phase and the
sound will suffer.
• Use only Neutrik NL4FC plugs for connecting Speakon connec-
tors.
Yamaha cannot be held responsible for damage caused by
improper use or modifications to the device.
* Illustrations in this manual are for explanatory purposes only,
and may not match the actual appearance of the product during
operation.
* Company names and product names used in this Owner's Man-
ual are trademarks or registered trademarks of their respective
owners.
1+ : HOT(+)
1– :COLD (–)
2– (NO USE)
2+ (NO USE)
Neutrik NL4FC connector
Quicklinks ausblenden:
Werbung
