Setting Menu - Pioneer KRF-9000FD Bedienungsanleitung

4
Setting Menu (Continued)
Picture > Gamma
H
Gamma
Sets the gradation characteristics of the projected image.
Standard
Movie 1
Movie 2
Dynamic
User
(Gamma Setup)
"Standard" is suitable for normal circumstances but other settings can be selected according to your preferences.
This setting can also be configured from the remote control. (pP10)
*"Gamma Adjust"
A Select the reference gamma curve coefficient (1.8 to 2.6) in "Correction Value".
B Select the colour to be adjusted in the gamma adjustment screen.
Correction Value
Gamma Adjust
Save
Load
All Reset
C Adjust the gamma curve in the gamma curve adjustment screen.
Correction Value
Gamma Adjust
Save
Load
All Reset
Adjustment Point (R)
X: 5 %
Y: 51
Select the point where the gradation (brightness) is to
be adjusted with the H / I buttons.
D To end
EXIT
If gamma curve is adjusted repeatedly, calculation errors will be accumulated and the gamma curve may not be able to
revert back to its original form. In that case, select the coefficient in "Correction Value" again or retrieve the previous gamma
data using "Load".
24
Settings
For normal circumstances, select this setting.
Sets gamma to "Movie 1".
Sets gamma to "Movie 2".
Select this when in well-lighted areas (such as living room) or when playing games.
The gamma can be set according to your preferences.
Correction Value
Gamma Adjust *
Save
Load
All Reset
W
R
G
B
1023
512
0 50 100 (%)
EXIT
EXIT
The coefficient (1.8 to 2.6) of the gamma curve can be selected.
The gamma curve for the colours (R, G, B) can be adjusted
separately.
Adjusting "W" will adjust for all "R, G, B" values. Gamma curves
are represented by a "G".
Saves the adjusted gamma data.
Loads the gamma data that was saved.
Returns the gamma coefficients to the values set by "Correction
Value".
Correction Value
Gamma Adjust
Save
Load
All Reset
Adjustment Point (R)
X: 5 %
Y: 51
Adjust the gradation (brightness) with the
J / K buttons.
Do you want to save Gamma data?
Yes : Push [ENTER] button
No : Push [EXIT] button
1023
512
0 50 100 (%)
ENTER