Please note the included General Safety Notes and the
following safety notes to avoid malfunctions, damage
or physical injury:
Persons with limited physical, sensorial or mental abilities are
not allowed to use the unit, unless they are supervised and
briefed for their safety by a qualified person.
Make sure, the operating voltage stated on the type label
corresponds to the power mains available in your area.
The unit is designed for operation in altitudes of up to 2000 m
above sea level.
Before each use please check the power cable for any
damages. If there are any damaged spots have the power
cable replaced by a professional.
Before starting any work on walls, floors or similar, make sure
that all power lines in the work area are switched off at the
main switchboard. Inspect the proposed drill hole location for
any utility lines (e. g. water, gas, power) before drilling. Use a
suitable device such as a metal or electricity line detecting
device.
Make sure the cord cannot get caught in any way.
Do not jam the cord or wind the cord around the unit and do
not bend it. Do not pull the cord around edges. Do not pinch
the power cord in any way and keep it away from hot
surfaces.
Make sure that the ventilation louvers are clean and free from
obstructions.
Please switch OFF the unit and unplug from the power supply
before cleaning, maintaining or when not in use.
Use the auxiliary handle delivered with the unit. Loss of
control of the pneumatic impact drill can cause injuries.
Always wear ear protection when working with the pneumatic
impact drill. The noise can head to ear damage. Wear a dust
Safety Notes
4