Herunterladen Inhalt Inhalt Diese Seite drucken

Mains Connection; Operation; If There Is Still Air In The Equipment, Please Proceed As Follows - Parkside PHD 100 D2 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PHD 100 D2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Mains connection

The pressure washer you have acquired is
already fitted with a mains plug. The pres-
sure washer must only be connected to an
earthed socket 230 V ~ 50Hz.
Only operate the pressure washer
after all the above points have been
observed.
Ensure that the pressure washer is
turned off by its ON / OFF switch (
5).
Insert the mains plug into the mains
socket

Operation

Connect the equipment to the water
tap. Observe the regulations for the
use of a system separator.
Turn on the water tap entirely.
Never operate the pressure washer
with a closed water tap. Dry run-
ning will damage the washer!
Be prepared for the recoil
force of the emitted wa-
ter jet! Ensure that you are
standing firmly and that you
are holding the gun (
securely, otherwise you could
injure yourself or other peo-
ple.
Switch on the pressure washer with the
ON / OFF switch (
Pull the lever of the gun (
on the washer.
Hold the switch-on lever of the gun
A
(
10) until there is no more air in the
pressure washer.
A
A
5)
A
5).
A
10) to turn
Releasing the lever will switch
off the washer, but the pressure
within the system is retained.
Lock / unlock the switch-on lever
D
of the gun (10) by depressing
the locking button (17).
Lock the switch-on lever to prevent
the pressure washer from being in-
advertently / accidentally started.
Locked
Open
In case of leaks in the water
system, immediately switch
off the equipment at the on/
off switch (5) and disconnect
the mains cable (7) of the
equipment from the mains.
There is a risk of electric
shock. Start restoring the wa-
ter connections (see "Initial
Operation – Setup").
If there is still air in the equipment,
please proceed as follows:
Bleed the supply hose:
1. Remove the quick connection for the
garden hose adapter on the water
connection (8) and open the water tap
until water with no bubbles emerges.
2. Close the water tap.
3. Connect the supply hose to the equip-
ment with the aid of the quick connec-
tion for the garden hose adapter (8).
4. Fully open the water tap.
GB
35

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

63638

Inhaltsverzeichnis