Advice On Use - Parkside PWS 125 A1 Bedienungs- Und Sicherheitshinweise

F or safety reasons this device must
always be used with the auxiliary
handle in place.
4
T he adjustable disc guard cover
always be in place when working with
roughing, grinding or cutting discs.
otherwise there could be danger of injury.
U se the vacuum dust extraction facility
if your work generates high amounts
of dust. Use suction devices particular-
ly approved for the purpose.
U se permitted consumables and tools
only. Check that the speed given on the
discs is greater or equal to the rated
speed of the device.
T ake note of the direction of rotation
and always hold the device in such a
way that the sparks and grinding de-
bris are thrown away from your body.
otherwise there could be danger of injury.
M ake sure that the dimensions of the
disc are suitable for the device and
that the disc is of a type that fits prop-
erly on to the mounting flange

Advice on use

Q
Note! Discs must be used only for their recom-
mended purposes, otherwise they could disintegrate,
become damaged or cause accidents.
Roughing (see Fig. G):
Never use cutting discs for
roughing or grinding!
M ove the angle grinder using even
pressure to and fro over the workpiece.
H old the roughing or grinding disc at
a flat angle to the workpiece when
working on a soft material. Use a
slightly steeper angle for harder ma-
terials.
General safety advice for electrical power tools
Disc-cutting (see Figs. E, F):
Never use roughing or
grinding discs for cutting!
must
5
O nly use certified fibre-reinforced cut-
ting or grinding discs approved for use at
circumferential speeds of not less than 80 m / s.
CAUTION! The disc continues to rotate after
the device has been switched off. Do not at-
tempt to slow it down by pressing on the side
of the disc.
S ecurely support the workpiece. Use
clamps or a vice to grip the workpiece firmly.
This is much safer than holding it in your hand.
S witch the device off and allow it to
come to a complete standstill before
you put it down.
U nlock the ON / OFF switch immedi-
ately if a power failure occurs or the
plug is pulled out of the mains socket.
Place the switch in the OFF position.
This prevents the device from being inadvertent-
ly started up again.
. U se the device for dry cutting or dry
8
grinding only.
T he auxiliary handle
whenever the device is being used.
D o not work on materials containing
asbestos. Asbestos is a known carcinogen.
A tip! Using the device safely.
disc. If you work in the other direction there is
the risk of kickback. The device may be forced
out of the cut.
A lways switch on the device before
placing it against the workpiece. After
cutting or grinding, always lift the device from
the workpiece before switching it off.
W hen working always hold the device
securely with both hands (see Fig. G).
Always keep proper footing and balance.
must be in place
4
DANGER! Always guide
the device through the
workpiece against the di-
rection of rotation of the
GB 45