Sound Settings; Picture Settings; Forced Settings In Programme Mode - Grundig ELEGANCE 70 ST 70-300 DOLBY Servicehandbuch

GRUNDIG Service
4.3.9 IF Type
Call up the "IF type" menu via "EASY DIALOG" –> "Installation" –>
"Only for the retailer" –> Code number "8500" –> "Special functions".
After replacing the NVM on the Signal module, it is necessary to adjust
the IF type:
Inland sets: Inland
Multi-8 sets: Multi 8
Multi-9 sets: Multi 9
(see Alignment, Point 16).
4.3.10 SAT Preprogramming (only with a SAT module fitted)
Call up the "SAT preprogramming" menu via "EASY DIALOG" –>
"Installation" –> "Only for the retailer" –> Code number "8500" –>
"Special functions".
Press "OK" for confirmation. This transfers the stored SAT station table
to the SAT module.

5. Sound Settings

Press the "blue" button to call up the "Sound settings" menu.
The settings "Voice", "Music", or manual can be selected in the
"Presettings" menu.
The "manual" setting allows you to adjust the sound to suit your taste.
For the other settings, specific values are preprogrammed.

6. Picture Settings

Press the "red" button to call up the "Picture settings" menu.
In the "Presettings " menu, the settings "During the day", "In the
evening", and "manual" can be selected.
With the "manual" option, you may set the contrast and the picture
sharpness. For the other settings, specific values are preprogrammed.
7. Settings via the Channel Allocation

7.1 Forced Settings in Programme Mode

Call up the "Sound channel" menu via "EASY DIALOG" –>
"Programme chart" –> "green button" –> "Change channel settings".
You may select between "autom.", "Mono", "Mono B" and
"Mono C".
Mono B = Original sound track
Mono C = For digital sound reception (Nicam).
1 - 26
DIGI 100