Guarantee Restrictions - HAPRO Topaz Anleitung

English
8
Environment
- The lamps of the appliance contain substances that may pollute the environment. When you discard the lamps, do not throw them away
with the normal household waste, but dispose of them at an official collection point.
- Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for
recycling. (Fig. 22)

guarantee restrictions

The following parts are not covered by the terms of the international guarantee:
- tanning lamps
- acrylic sheet
- cleaning costs of the acrylic sheet
Troubleshooting
If problems should arise with this appliance and you are unable to solve them with the information below, please contact your dealer.
Problem
The appliance does not start.
The fuse of the circuit to which the
appliance is connected cuts off the power
when you switch on the appliance or
when it is in use.
Poor tanning results
Solution
Make sure the plug has been properly inserted into the wall socket.
There may be a power failure. Check if the power supply works by connecting another appliance.
The timer may not have been set. Set the timer to the appropriate tanning time.
The lamp of the face tanner (10/1V only) may still be too warm to restart. Let the lamp cool
down for 3 minutes before you switch it on again.
The fuse of the circuit to which the tanning appliance is connected must be a 16A standard fuse
(in the UK 13A fuse)or a slow-blow automatic fuse. You may also have connected too many
appliances to the same circuit.
Perhaps you use an extension cord that is too long or does not have the correct current rating.
Consult your dealer. Our general advice is not to use an extension cord.
You may have followed a tanning course that is not appropriate for your skin type. Check the
table in section 'Tanning sessions: how often and how long?'.
Perhaps the distance between the lamps and your body is larger than prescribed.
When you have used the lamps for a long time, their tanning capacity decreases. This effect only
becomes noticeable after several years.To solve this problem, select a slightly longer tanning time
or have the lamps replaced.