Specifications; Important Safety Instructions - Makita AN923 Betriebsanleitung

ENGLISH
1. Compressor air output per minute
2. Nailing frequency (times/min.)
3. Pneumatic tool oil
4. Contact arm
5. Nose adapter
6. Adjuster
7. Hook
8. Pusher
9. Pusher lever
10. Depress

SPECIFICATIONS

Model
Air pressure
Nail Iength
Nail capacity
Dimensions (L x H x W)
Min. hose diameter
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be sure
that you understand their meaning before use.
............... Read instruction manual.
................ Wear safety glasses.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING:
WHEN USING THIS TOOL, BASIC SAFETY PRECAU-
TIONS SHOULD ALWAYS BE FOLLOWED TO
REDUCE THE RISK OF PERSONAL INJURY, INCLUD-
ING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and
maintenance of the tool, read this instruction man-
ual before using the tool.
• Always wear safety glasses to protect your eyes
from dust or nail injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators and
by other persons in the immediate working area.
• Wear hearing protection to protect your ears
against exhaust noise and head protection. Also
wear light but not loose clothing. Sleeves should
6
Explanation of general view
11. Return
12. Nail stopper
13. Air socket
14. Air fitting
15. Continuous nailing
16. Trigger lock
17. Lock lever
18. Intermittent nailing
19. Hammer
20. Small rod
AN923
0.44 - 0.83 Mpa (4.4 - 8.3 bar)
64 - 74 pcs.
559 mm x 347 mm x 109 mm
END101-1
ENB067-2
21. Ejection port
22. Driver
23. Pliers
24. Slot
25. Trigger lock
26. Change lever
27. Drain cock
28. Air filter
29. Oiler
30. Pneumatic oil
50 mm - 90 mm
455 mm x 365 mm x 109 mm
8.5 mm
3.9 kg
be buttoned or rolled up. No necktie should be
worn.
• Rushing the job or forcing the tool is dangerous.
Handle the tool carefully. Do not operate when
under the influence of alcohol, drugs or the like.
• General Tool Handling Guidelines:
1. Always assume that the tool contains fasten-
ers.
2. Do not point the tool toward yourself or any-
one whether it contains fasteners or not.
3. Do not activate the tool unless the tool is
placed firmly against the workpiece.
4. Respect the tool as a working implement.
5. No horseplay.
6. Do not hold or carry the tool with a finger on
the trigger.
7. Do not load the tool with fasteners when any
one of the operating controls is activated.
8. Do not operate the tool with any power source
other than that specified in the tool operating/
safety instructions.
• An improperly functioning tool must not be used.
• Sparks sometimes fly when the tool is used. Do not
use the tool near volatile, flammable materials such
as gasoline, thinner, paint, gas, adhesives, etc.;
they will ignite and explode, causing serious injury.
• The area should be sufficiently illuminated to
assure safe operations. The area should be clear
and litter-free. Be especially careful to maintain
good footing and balance.
AN943
60 - 84 pcs.