Power Tool Use And Care; Service; Safety Advice For All Uses - Parkside 273273 Originalbetriebsanleitung

to power source and/or battery pack, picking
up or carrying the tool. Carrying power tools
GB
with your finger on the switch or energising
power tools that have the switch on invites
accidents.
d) Remove any adjusting key or wrench before
turning the power tool on. A wrench or a key
left attached to a rotating part of the power tool
may result in personal injury.
e) Do not overreach. Keep proper footing and
balance at all times. This enables better control
of the power tool in unexpected situations.
f) Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewel-
lery or long hair can be caught in moving parts.
g) If devices are provided for the connection of
dust extraction and collection facilities, ensure
these are connected and properly used.
Use of dust collection can reduce dust-related
hazards.

4. Power tool use and care

a) Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at
the rate for which it was designed.
b) Do not use the power tool if the switch does not
turn it on and off. Any power tool that cannot
be controlled with the switch is dangerous and
must be repaired.
c) Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tool's operation. If damaged, have the
4
power tool repaired before use. Many accidents
are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and accessory
tools etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation.

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
b) Always arrange for the exchange of the plug
or the power cord to be carried out by the
manufacturer of the appliance or by its ap-
proved customer services. This will ensure that
the safety of the power tool is maintained.

Safety advice for all uses

General safety advice for grinding polishing
and disc-cutting:
a) This electrical power tool is intended for use as
a grinding and disc-cutting machine. Observe
all the safety advice, instructions, information in
figures and all other information you received
with this device.
If you do not observe the following advice it could
lead to electric shock, fire and /or serious injury.
b) Operations such as sanding, wire brushing
or polishing are not recommended to be per-
formed with this power tool Operations for
which the power tool was not designed may
create a hazard and cause personal injury.
c) Do not use any accessory not specifically
intended by the manufacturer for this electrical
power tool. Although an accessory may fit on
your electrical power tool, this does not on its
own guarantee that it can be safely used.
d) The maximum permitted speed of an attach-
ment must be at least as high as the maximum
speed indicated for the electrical power tool.
An accessory rotating faster than its permitted
PWS 230 B2