Operation
Filling the magazine shaft
♦
Before commencing work with the appliance, set the on/off
switch
♦
Turn the appliance around.
♦
Press the release
♦
Pull the magazine slider
♦
Fill the magazine shaft
♦
After filling, push the release
far as the stop until it clicks into place.
NOTE
►
The fill level indicator
contains staples.
Use
Switch on
♦
To switch the appliance on, set the on/off switch
♦
Press the tacker nose
you want to staple until it is pushed in a few millimetres.
♦
Press the trigger
♦
To switch the appliance off, set the on/off switch
Troubleshooting
Cause:
A staple is blocking the appliance.
│
GB │ MT
■
32
to "0".
together (see Fig. A).
with staples (see Fig. B).
shows whether the magazine
onto the location on the material that
.
backwards (see Fig. A).
into the magazine shaft
as
to "I".
to "0".
PAT 4 A1