Werbung
c) Change over to 12-/24 hour mode
• Pr
ess the button "MODE" (D) so often until "TIME"
appears briefly in the lowest line of the display.
• Using the button "12/24" (M) on the rear of the multi-
compass, it is possible to switch between the12 and 24-
hour modes.
d) Setting date
• Pr
ess the button "MODE" (D) so often until "DATE" is
faded briefly into the lowest line of the display. The current
date is then displayed.
• Press the button "SET" (G) for longer than 2 seconds
until the date display begins to flash. Release the button
again.
• Set the date on the rear of the multi-compass using the
buttons "MONTH" (I), "DATE" (N) and "YEAR" (M).
• By pressing the button "MODE" (D), you return to the
normal display, the date which you have set is stored auto-
matically.
e) Setting world time and world date
•
Press the button "MODE" (D) so often until "WTM"(world
time) is displayed in the lowest line of the display. After
this, the lowest line of the display displays the current
place for the world time (e.g. "PAR" for Paris; see table in
the appendix) and the world time set.
50
• Press the button "SET" (G) briefly. "REF" is faded into
the lowest line of the display. This stands for "refer-
ence value", i.e. a certain, known height of the place
at which you are located e.g. the starting point of a
wandering (height for example. in a map).
This increases the exactitude of the subsequent
height display. Please note that air pressure
changes in the course of the day have an influ-
ence on the display of the altimeter!
• Set the reference value using the buttons "+" (I) and "-"
(N) on the rear of the multi-compass. If the button is held
down for a longer period, the quick adjustment is activat-
ed.
At the current height (e.g. 350m), the reference value
"OFF" is displayed.
• Press the button "SET" (G) briefly. "RATE" is displayed in
the lowest line of the display. This concerns the time dif-
ference in which a height change is stored by the multi-
compass (pixel diagram for height change bottom of dis-
play). 5, 15, 30 and 60 minutes can be set.
• Using the keys "+" (I) and "-" (N), the desired value can
be set on the rear of the multi-compass (value flashes). If
the button is held down for a longer period, the quick
adjustment is activated.
• By pressing the button "SET" (G) briefly, the order of
adjustment starts from the beginning again (height alarm
> reference value > height storage). Press the button
"MODE" (D) to return to the key again.
55
Werbung
Kapitel
