Herunterladen Diese Seite drucken

Conrad 84 05 57 Bedienungsanleitung Seite 45

Werbung

• The multi-compass has to be operated horizontally. For
this reason, a small mini bubble level is built into it (sim-
ilar to a spirit level). The small air bubble in the bubble
level has to lie exactly within the circle.
• In case of very strong disturbance (magnetic or electric
fields, shielding from buildings etc.), it can happen that
no compass display appears. Move away from the cause
of the disturbance.
The multi-compass should therefore be operated
primarily in the open-air. Make sure that it does
not become damp or wet (e.g. in the rain).
Observe the safety instructions and the section
"handling".
Activate the compass display by pressing the button "COM-
PASS ON/OFF" (E) briefly.
T
his functions in the operating modes time, date,
alarm, altimeter and barometer.
If the compass display is switched off (when the
compass display is no longer required), the ser-
vice life of the batteries is extended..
The numeric direction display follows in 5°-steps from 0° to
355°.
The display of the compass rosette follows in 22.5° steps.
For the cardinal points, there is a corresponding fade-in (N,
NE, E, SE, S, SW, W, NW; 45° steps).
60
Please observe:
The buttons on the front and the rear of the multi-
compass are in some cases allocated more than
once. Depending on the activated operating mode,
the buttons therefore have different functions. The
labelling on the multi-compass is multicoloured to
simplify operation.
A The lifted cover with brief instructions (in English) for cal-
ibrating the compass.
B LC display with diverse displays
C Button "SNOOZE/LIGHT/CALIBRATION SPLIT/CLEAR"
• Background lighting on
• Slumber feature
• Calibrate compass
• Interim time for stopwatch, reset for stopwatch
D Button "MODE"
Selecting operating mode/features
E Button "START/STOP COMPASS ON/OFF"
• Start/Stop for stopwatch
• Compass display on/off
F Mini bubble level to enable the multi-compass to be posi-
tioned horizontally for operation and for calibration
G Button "SET/ADJUST MEMORY"
• Change setting
• Display memory for interim times of the stopwatch
45

Werbung

Kapitel

loading