Renkforce 1052399 Bedienungsanleitung Seite 26

(1) GAIN controller
These dials adjust the mixer input to the respective output level of the source of signal (record player, CD
player, etc.).
(2) BASS / TREBLE controller
These controllers adjust the volume of the respective channel.
The farther the respective controller is turned clockwise, the louder the respective frequency range is
played back.
In the middle position of the respective controller, the sound is not influenced.
(3) CUE1 / CUE2 controller
This controller determines playback of the pre-listening signals of CH1 and CH2 for the headphones.
Position CUE1:
Position CUE2:
Middle position:
(4) Channel faders
These controllers adjust the volume of the respective channel.
Controller pushed down:
Controller pushed up:
The channel fader for channels that are not in use should be pulled down. This reduces the dan-
ger of introducing interference noises.
(5) USB TO CH-2 switch
This switch activates playback via the USB connection.
Position ON:
Position OFF:
(6) CUE VOLUME control
This controller adjusts the volume of the headphones.
Turn the controller to the MIN position before plugging in, unplugging or putting on the head-
phones or before switching the mixer on or off. There is a danger of damage to your hearing from
excessive volume at the headphones output.
(7) MIC/AUX VOLUME controller
This controller sets the volume of the microphone and the AUX input.
(8) Crossfader
Use this controller for crossfading between the channels CH 1 and CH 2.
One channel is faded out when the slider is operated (volume decreases), while the other is faded in at the
same time (volume increases).
When the crossfader is in centre position, both channels are played equally.
26
Channel 1 is played back via the headphones.
Channel 2 is played back via the headphones
Both channels are played back via the headphones.
Minimum channel level
Maximum channel level
USB input activated, USB-signal is played back via channel 2
USB input deactivated