Performing An Angle Cut; Performing A Mitre Cut (Jolly Cut); Cleaning And Maintenance - Parkside PFSM 500 A1 Originalbetriebsanleitung

GB
face and against the parallel stop (9).
5. Turn the device on.
6. Push the workpiece evenly and not too
fast across the work surface through
the full-rim diamond cutting disc (15).
7. Always ensure that is a sufficient dis-
tance between your fingers and hands
and the full-rim diamond cutting disc
(15).

Performing an angle cut

1. Push the angle stop (11) on to the par-
allel stop (9).
2. Adjust the desired working angle on
the angle stop (11).
3. The angle can be read off on the sca-
le.
4. Fix the angle stop (11) in place with
the winged screw.
5. Ensure that the parallel stop (9) is
fixed in place, as required.
6. Place the workpiece on the work sur-
face and against the angle stop (11).
7. Turn the device on.
8. Push the workpiece evenly and not too
fast across the work surface through
the full-rim diamond cutting disc (15).
9. Always ensure that is a sufficient dis-
tance between your fingers and hands
and the full-rim diamond cutting disc
(15).
Note the reduced depth in the
case of a mitre cut.

Performing a mitre cut (jolly cut)

1. Place the folding work surface (4) in
position.
2. Fix the folding work surface (4) firmly
in place with the two set-up aids.
26
3. The work surface (4) can be fixed in
place at 22.5° and 45°.
4. Place the workpiece on the folding
work surface.
5. Turn the device on.
6. Push the workpiece evenly and not too
fast across the folding work surface
through the full-rim diamond cutting
disc (15).
7. Always ensure that is a sufficient dis-
tance between your fingers and hands
and the full-rim diamond cutting disc
(15).
A jolly cut may only be car-
ried out near the edge of the
workpiece.
Cleaning and
maintenance
Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described
in these instructions carried
out by a specialist workshop.
Use only original components.
Allow the equipment to cool
before carrying out any main-
tenance and cleaning work.
There is a risk of burns.
Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding disc. Re-
place damaged parts.