Working With The Blender - AEG Electrolux STM125X Anleitung

English

Working with the blender

The appliance can be used for up to 1 minute without
stopping. It should be allowed to cool afterwards for at
least 1 minute.
Important: Blades are very sharp, handle with
care. Ensure that the hand-held blender is
unplugged from the power outlet before
assembling or removing attachments.
Insert the blender deep into the bowl, then press switch A
(for speed I) or switch B (for speed II) (Figure 2).
Start all types of processing at speed I. This will avoid
powdery foods and liquids spraying out.
Light upward and downward movements of the blender
permit the material being worked on to be handled in the
best possible way. Please make sure that:
– the mixing attachment never has more than two-thirds
of its length immersed in the material,
– the mixing bowl is never more than two-thirds full (to
avoid the danger of splashes).
Working with the chopper
(ZSTM310) Figure 4 .
(STM1255)
Max operation duration under high speed per time
cannot exceed 1 minute, and 1 minute rest time must be
maintained at two consecutive cycles.
Place the chopper bowl on a clean, level surface.
Assemble the stainless steel blade into the chopper
bowl, as shown in position A.
Place food into the chopper bowl.
Note: remove the bone of the meat, cut small
piece (approximately 10-15 mm), then place the
meat into the bowl, the max quantity of meat
can't exceed 200g in every blending.
Attach the lid onto the chopper bowl and turn it in
clockwise direction until it locks into position (see
position B).To detach the lid, turn in adverse direction.
Insert the top part of the chopper into the hole of the
chopper lid, and turn in clockwise direction to lock (see
position C).
8
ELX13669_IFU_Stickmixer_AEG_3lang_insert.indd 8
Plug the appliance to power outlet and depress the
switch to begin operation.
To stop the appliance, release the switch at the top of the
motor unit.
Caution: To reduce the risk of injury, never place
cutting blade on base without first putting bowl
properly in place.
Be sure chopper lid is securely locked in place before
operating appliance.
Working with the egg white
beater (ZSTM310) Figure 5 .
(STM1255)
Max operation duration under high speed per time
cannot exceed 1 minute, and 1 minute rest time must be
maintained at two consecutive cycles.
To assemble the egg white beater with the motor unit,
turn the motor unit clockwise direction until tightened.
To disassemble, turn in the adverse direction (see
position A).
Plug the hand-held blender to power outlet.
Place egg white into the cup, generally, put two egg
white is enough (see position B).
Lower the hand-held blender into food and depress the
switch at the top of the motor unit (see position C).
To stop the hand-held blender release the switch at the
top of the motor unit.
Fixing wall bracket (ZSTM310)
Figure 6.
You can fix the wall bracket as following:
Drill two same holes in wall and strictly follow the
dimension as indicated.
Knock two plastic tubes in them with hammer.
Secure the bracket on wall with another two screws.
7
(STM1255)
2010-07-01 11:21:32
Eng