Cleaning And Care - AEG Electrolux KM 700 Gebrauchsanweisung

822_949_249 KM700.book Seite 24 Dienstag, 22. Januar 2008 10:09 22
g
Operating multifunction section
0 Open cover (fig. 1/F) and place all
ingredients required in the all-purpose
bowl.
Caution: Do not exceed maximum fill-
ing volume:
– liquid 1.75 litres
– solid 1.5 litres
3 Further ingredients can be added dur-
ing operation through the filling inlet.
The filling beaker in the stopper (fig.
1/E) can also be used for this purpose.
Close the filling inlet immediately each
time to avoid splashes.
Use the stopper exclusively to com-
1
press the cutting items!
0 Start the appliance: turn speed selector
(fig. 1/l) right to the desired speed set-
ting or press the pulse button (fig. 1/J).
It is recommended to start at a slow
3
speed and then to increase the speed.
The appliance operates at maximum
speed by pressing the pulse button.
Refer to the section "Tips on using
multifunction section" for reference
values.
If the warning lamp (fig. 4/a) flashes
1
and the appliance cannot be started,
the safety cover for the mixer drive
(figs. 1/R and 4) is not properly fitted.
0 Switch off appliance: turn speed selec-
tor left to the "0" position.
0 After using, turn cover clockwise and
remove.
Only remove the cover when the tool
1
has come to a complete stop!
0 Remove the tool and spindle.
0 Turn the all-purpose bowl clockwise
and remove.
24

Cleaning and care

Motor casing
1 Ensure that no liquid enters the motor
casing!
0 Clean the motor casing with a moist
cloth. Never immerse in water or hold
under running water!
Mixer
3 Container and blade can be cleaned
easily and properly with the aid of the
pulse position.
0 Fill the mix container half full with
warm (not hot!) water and add a few
drops of detergent.
0 Press the pulse button briefly.
0 Then rinse the container under running
water.
Dismantle/fit blade unit (fig. 13)
3 If necessary, the blade unit can also be
dismantled and cleaned separately.
1 Caution: The blade is very sharp!
Danger of injury!
0 Release blade unit (fig. 13/a) from mix
container using the closing cover
(fig. 1/D and fig. 13/c) as tool. The
grooves of the closing cover fit the ribs
of the blade unit. Turn counter-clock-
wise and remove while holding slightly
at an angle.
0 Remove gasket (fig. 13/b) from blade
unit.
1 The blade unit is very sharp. The gasket
can be damaged.
Rinse the components carefully by
1
hand (danger of injury!). Use only
water and detergent for cleaning.
Do not clean the blade unit in a dish-
washer.
0 Insert gasket in blade unit.