Mounting Of The Dispenser; Preparation For Installation - ophardt ingo-man plus Original Bedienungsanleitung

6. Mounting of the dispenser

6. Mounting of the dispenser
6.1 Preparation of the installation
Place the dispenser above the washstand or right next to it. If this is not possible, one has to take care
by means of adequate equipment that no medium pours out on the floor.
• Prior to the use of new filling media tests are required!
• Please pay attention to that during installation
no radiation-emittent object (i.e. X-ray apparatus,
mobile telephone... etc.) is in the near proximity.
Electromagnetic interference sources and/or radiating
electric fields may impair the function.
Prior to the mounting of the dispenser
please observe the following
• Required place above the dispenser:
40 mm (for putting on and removing from the mounting plate).
Please take the required place below the dispenser from the
dimensioned sketch.
• Suitable mounting height:
130-135 cm, measured from the
floor up to the upper edge of the dispenser.
IMP Touchless - Instruction manual
ingo-man plus
®
30