Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Possible Cause - Parkside PFDS 33 A1 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PFDS 33 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Troubleshooting

Malfunction
No function.
Irregular wire feed.
No wire feed.
Wire feed not adjustable.
No welding current with
normally functioning wire
feed.
Torch is getting too hot.
Welding current too low.
14 │ GB

Possible cause

Incorrect mains connection.
The overload protection has
activated.
Not enough pressure on the
feed roll.
Wire not lying correctly in the
groove of the feed roll or the
groove is too big or the wire
feed roll is worn.
Poorly wound wire; crossed
wires.
Torch switch or control line in
cable assembly defective.
Adjusting wheel or control circuit
defective.
Cable assembly or earth cable
defective.
Control circuit defective.
Flow nozzle loose or too large.
Bad earth contact.
Remedy
Check mains fuse or have the mains supply checked by a technician.
Allow the appliance to cool down.
Increase pressure.
Place wire correctly in the groove of the feed roll or, if necessary, replace the
feed roll.
Replace wire roll.
Please contact our service department.
Please contact our service department.
Check cable assembly and earth cable and, if necessary, contact the service
department.
Tighten or replace flow nozzle.
Check the earth clamp and cable as well as the cable assembly.
If necessary, contact our service department.
PFDS 33 A1

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis