Kessebohmer ergoAGENT base Bedienungsanleitung Seite 27

Problem
Worktop is on a slant
One column fails to
move during Reset
travel
If your attempts at troubleshooting are unsuccessful, unplug the ergoAGENT base from the
mains power supply and contact the manufacturer's customer service.
27 l KESSEBÖHMER
Solution
- Remove the excess load and carry out a Reset (see page 11).
- If this does not eliminate the problem, unplug the power cable
and then plug it in again and carry out a Reset.
- If the problem cannot be eliminated, or if it occurs repeatedly,
contact your service partner.
- Check the power connections of this column.
- Make sure that the island was assembled free of stress
- Contact your service partner.
ergoAGENT base l 27