Use; Fitting The Blade Guard With Quick Release - Parkside PWS 230 C3 Originalbetriebsanleitung

■ When working on angled surfaces, do not
exert great force on the workpiece. If the
rotational speed drops significantly, you must
reduce the pressure exerted to allow safe and
effective working. If the appliance suddenly
brakes completely or jams, it must be switched
off immediately.
■ Cutting: Work at a moderate feed rate and
do not tilt the cutting disc.
■ Roughing and cutting discs become very
hot – let them cool down completely before
touching them.
■ Never use the appliance for purposes other
than the ones for which it was designed.
■
Always make sure that the appliance is
turned off before plugging it into the wall
socket.
■
In case of danger, remove the plug from the
socket immediately. Ensure that the appliance
and the power socket are easily and quickly
accessible in the event of an emergency.
■ Always remove the plug from the power
socket during work breaks, when adjusting
the appliance and when it is no longer in use.
The appliance must be kept clean, dry and free
of oil and grease at all times.
■ Remain alert at all times! Always pay atten-
tion to what you are doing and act with com-
mon sense. Do not use the appliance if you are
distracted or feeling unwell.
WARNING!
Always wear safety googles.
WARNING!
Always wear a dust mask!
■ 40 │ GB

Use

Fitting the blade guard with quick
release
WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
RISK OF INJURY
► Always use the angle grinder with the blade
guard . The blade guard should be fitted
securely. Set it so that the highest possible
degree of safety is achieved, i.e. the smallest
possible part of the grinding disc is open to
the operator. The blade guard
to protect the operator from fragments and
accidental contact with the grinding tool.
RISK OF INJURY
► Make sure that the blade guard
at least at the same angle as the additional
handle (see fig. B). Otherwise, you could
cut injure yourself on the roughing disc or
cutting disc.
♦ Open the clamping lever
♦ Place the blade guard
in the coding groove
♦ Turn the blade guard
(working position). The closed side of the blade
guard must always be toward the operator.
♦ Close the clamping lever
blade guard into position. If necessary, the
clamping force of the lock can be changed by
loosening or tightening the adjusting screw
Ensure that the blade guard
neck of the spindle.
is designed
is fitted
.
with the coding pin
.
to the required position
to clamp the
.
sits firmly on the
PWS 230 C3