Safety Instructions For Grinding Tools - Parkside PTS 500 A1 Originalbetriebsanleitung

Safety instructions for grinding tools

a) General
Grinding tools are very fragile and likely to break
which is why great care must be taken when han-
dling the grinding tools. Using damaged, incorrect-
ly clamped or incorrectly installed grinding discs is
dangerous and may cause serious injury.
b) Handling, transport and storage
Grinding tools are to be treated with care and
transported carefully. Grinding tools should be
stored in such a way that they are not exposed
to mechanical damage or harmful environmental
influences.
Avoid any risk of an electric shock.
■ Check the condition of the device, power cord
and power plug at regular intervals. Stop using
appliances where the aforementioned parts are
damaged. Never open the device. Damaged
appliances, power cords or power plugs cause
danger to life by electric shock. Have repairs
and replacement work done only by the Service
centre or a qualified electrician.
■ Do not operate the appliance if it is damp or in
a humid environment.
■ When working outdoors, connect the appliance
via a fault current circuit breaker with a max-
imum tripping current of 30 mA. Use only an
extension cord approved for outdoor use.
NOTE
► Always hold the power cord away from the
working area of the machine and run it to the
rear away from the machine.
│ GB │ MT
■ 26
WARNING! Protect yourself from laser
radiation!
LASER
P max.: < 1 mW • λ: 650 nm •
EN 60825-1:2014
This appliance contains a Class 2 laser.
► NEVER direct the laser beam at people or
animals.
► NEVER look directly into the laser beam.
The laser beam can cause serious eye damage.
► Do NOT direct the laser beam at strongly
reflective material. Reflected laser beams are
also dangerous.
► Any adjustment intended to increase the
intensity of the laser beam is forbidden.
There is a risk of personal injury!
► No liability will be accepted for damage
resulting from manipulation of the laser
equipment or from disregarding these safety
instructions.
► Caution if other than the controls or adjust-
ments specified here or other procedures
are carried out, this may lead to dangerous
exposure to radiation.
NOTE
► If the device is not used according to the
manufacturer's operating instructions, the
protection provided may be impaired.
DANGER
Mishandling the batteries can cause
fires, explosions, leakages or other
hazards!
► Do not throw the batteries into a fire and do
not subject them to high temperatures.
► Do not open, deform or short-circuit batteries,
since this can lead to chemical leakage.
2
PTS 500 B2