Processing Of Warranty Claims; Service; Label Meanings - Parkside PSH 3 A1 Originalbetriebsanleitung

This product is intended for private, non-commercial
use only. Any incorrect or improper use of the device,
use of force and changes not performed by our au-
thorized service branch will void the warranty.

Processing of warranty claims

Please follow the instructions below to ensure your
claim is processed quickly:
When inquiring about your product please have
your receipt and product number (e.g. IAN) ready
as your proof of purchase.
The product number can be found on the type plate,
an engraving, the cover page of your instructions
(bottom left) or the decal at the back or bottom.
In the event of malfunctions or other defects, please
first contact the service department below by phone
or e-mail.
A product recorded as defective, along with the
proof of purchase (sales receipt) and a description
of the defect and when it occurred, can then be re-
turned free of charge to you to the service address
provided.
Note: On www.lidl-service.com you can
download this as well as many other
manuals, product videos and software.

Service

Only use original accessory parts:
Viewing pane 114.5 mm x 89.5 mm
Rear pane 103.8 mm x 47.3 mm.
How to contact us:
GB, IE
Name: C. M. C. GmbH
Website: www.cmc-creative.de
E-mail: service.gb@cmc-creative.de
service.ie@cmc-creative.de
Phone: 0-808-189-0652
(£ 0,10 / Min.)
Registered office: Germany
Warranty terms / Service / Label meanings
IAN 281392
Please note that the following address is not a service
address.
Please first contact the service point named above.
Address:
C. M. C. GmbH
Katharina-Loth-Str. 15
DE-66386 St. Ingbert
GERMANY

Label meanings

Safety viewing panels approved accord-
ing to DIN EN 166: CMC 1 F CE
(Legend: CMC = manufacturer code, 1 = optical
class, F = low power shock, CE = CE symbol)
ADF approved according to DIN EN 379:
(Legend: 4 = bright state, 9–13 = dark state, CMC =
manufacturer code , number 1 = optical class,
number 2 = scattered light grade, number 3 = homo-
geneity class, number 4 = angle dependency class,
379 = test standard, CE = CE symbol)
Welding helmet case
Manufacturer identification .................CMC GmbH
Number of the standard ......................EN 175
Area(s) of application (if required) .........S, F, B
Mass in grams (if required)
Protection
Symbol
type
increased
S
strength
Low energy
-F
impact
Medium
-B energy
impact
Description of
scope
of application
Mechanical strength
Mechanical strength
Mechanical strength
GB/IE/NI 11