Before first use
Fitting the coil spring
♦
Push the bracket of the coil spring
provided on the soldering station (see fold out page).
GB
Inserting/replacing the soldering tip
CAUTION! RISK OF BURNS!
►
Never heat the soldering iron
■
The soldering tip may only be removed when the appliance is
switched off and the soldering tip is cooled down.
■
The soldering tip has a screw thread and can thus be removed
quickly from the soldering iron.
♦
Unscrew the soldering tip anticlockwise.
♦
Screw the soldering tip in clockwise.
NOTE
►
Before use remove the protective cap from the soldering tip
►
Before using the soldering station for the first time and also
before using a new soldering tip, the soldering tip
tinned.
Procedure:
♦
Plug the mains plug into a wall socket and press the ON/OFF
switch
♦
Set the temperature control
appliance has heated up. Allow a little bit of solder
into a thin film on the soldering tip.
42
to position "I".
up to the stop into the slot
without a soldering tip
to level 3 and wait until the
.
.
must be
to melt
PLS 48 C1