Cleaning, Maintenance And Ordering Of Spare Parts - Einhell Tc-Ld 40 R Originalbetriebsanleitung

•
Front edge reference point (see Fig. 4)
•
Rear edge reference point (see Fig. 4)
6.4 Using the measurement functions
Note:
The laser beam switches off automatically after
completion of each measurement. Press the ON/
Measuring button.
6.4.1 Function: "Measure single distance"
"No symbol" (Fig. 5)
Procedure:
•
Press button A once:
Switch on the equipment
•
Press button B for longer if necessary:
Select the reference point on the equipment
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure
→ The result is displayed at the bottom in m
6.4.2 Function: "Measure areas"
"Symbol " (Fig. 6)
Procedure:
•
Press button A once:
Switch on the equipment
•
Press button B once: Select function
•
Press button B for longer if necessary:
•
Select the reference point on the equipment
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the area length
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the area width
→ The result is displayed at the bottom in m²
6.4.3 Function: "Measure volume"
"Symbol " (Fig. 7)
Procedure:
•
Press button A once:
Switch on the equipment
•
Press button B twice: Select function
•
Press button B for longer if necessary:
Select the reference point on the equipment
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the room
length
GB
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the room width
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the room
height
→ The result is displayed at the bottom in m³
6.4.4 Function: "Measure continuous dis-
tance (min/max)"
"Symbol
Procedure:
•
Press button A once: Switch on the equip-
ment
•
Press button B three times: Select function
•
Press button B for longer if necessary: Select
reference point
→ The highest measurement result so far is
displayed at the top in m
→ The lowest measurement result so far is
displayed in the center in m.
→ The current measurement result is dis-
played at the bottom in real time
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before start-
ing any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished us-
ing it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use clean-
ing agents
attack the plastic parts of the equipment.
Ensure that no water can seep into the de-
vice. The ingress of water into an electric tool
increases the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
- 12 -
" (Fig. 8 / 8a / 8b)
or solvents; these could