Before Operation - Vevor Rtd-46A Originalanleitung

Be sure to remove all packing material before use.

Place the unit on a well-ventilated, flat, sturdy surface away from heat

sources. The unit should not be used in the immediate vicinity of water
(such as bathtubs, washbowls, etc.) where the likelihood of immersion
may occur. Keep at least 30mm away from walls and other objects.
Plug cord into a power outlet.

Remove the wire basket and set aside.

1. Please fold or roll up the damp or pre-moistened towels but not soaked
ones into the wire basket of hot towel warmer. Try to wring out the water
several times to shorten the heating time.
2. 100% cotton dry towels could be put as well but not any other cloths
which couldn't bear this high temperature, and keep it within less than 2
hours heating. Please keep the towel away from the inner wall of warmer.
3. Do not overload the wire basket or directly place towels into the towel
warmer.
4. The button on the right is for the upper warmer layer. The button on the
left is for the lower warmer layer.
5. Close the door firmly and press the button to turn on the power and UV
sterilization system simultaneously. The towel cabinet has started heating
and sterilizing. The indicator near the switch will be on to show that the
towel cabinet has started working.
6. It will take approximately 1.5 to 2.5 hours, depending on the number of
towels placed inside the cabinet. While keeping the cabinet door closed,
the temperature inside the cabinet will rise to the set temperature and will
automatically remain at this temperature. Do not open the cabinet door
while the towels are being heated.
7. When you want to add more towels, simply press the power button. The

BEFORE OPERATION

OPERATION
5