Epson TM-T88IV Benutzerhandbuch Seite 4

English
DIP Switch Tables
Serial Interface (DIP switch 1)
SW Function
1-1 Data receive error
1-2 Receive buffer
capacity
1-3 Handshaking
1-4 Data word length
1-5 Parity check
1-6 Parity selection
1-7 Transmission speed (See table below.)
1-8
Transmission speed
Transmission speed (bps)-bits per second
38400 *1
4800
9600
19200
Serial Interface (DIP switch 2)
SW Function ON
2-1 Handshaking Receive buffer
(BUSY condition) full
2-2 Do not change
2-3 Print density/ See Table A
2-4 Low power
2-5 Release condition Releases BUSY
of receive buffer when remaining
BUSY (If receive receive buffer
buffer capacity capacity
set to 4 KB.) reaches
138 bytes.
2-6 Do not change
2-7 I/F pin 6 reset Enabled
2-8 I/F pin 25 reset Enabled
*1. Only when DIP Switches 1-7 and 1-8 are on, the
transmission speed can be selected from one of
seven speeds: 2400, 4800, 9600, 19200, 38400, 57600,
and 15200 bps. The default is 38400.
iv
ON OFF
Ignored Prints "?"
45 bytes 4K bytes
XON/XOFF DTR/DSR
7 bits 8 bits
Enabled Disabled
Even Odd
1-7 1-8
ON ON
OFF ON
ON OFF
OFF OFF
OFF
Offline or
Receive buffer
full
Releases BUSY
when remaining
receive buffer
capacity
reaches
256 bytes.
Disabled
Disabled
Parallel Interface (DIP switch 1)
SW Function
1-1 Auto line feed
1-2 Receive buffer
capacity
1-3 Select paper
sensors to output
paper-end
signals (default
value of ESC C 3)
1-4 Error signal output
1-5~ Undefined
1-8
Parallel Interface (DIP switch 2)
SW Function ON
2-1 Handshaking Receive buffer
(BUSY condition) full
2-2 Do not change
2-3 Print density/ See Table A
2-4 Low power
2-5 Release condition Releases BUSY
of receive buffer when remaining
BUSY (If receive receive buffer
buffer capacity capacity
set to 4 KB.) reaches
138 bytes.
2-6 Do not change
2-7
2-8 I/F pin 31 reset (Do not change)
Table A
Print density/low power
– Low power consumption mode
Print density "Normal"
Print density "Medium"
Print density "Dark"
ON OFF
Always Always disabled
enabled
45 bytes 4K bytes
Disabled Roll Paper end
sensor enabled,
Roll Paper near-
end sensor
enabled
Disabled Enabled
OFF
Offline or
Receive buffer
full
Releases BUSY
when remaining
receive buffer
capacity
reaches
256 bytes.
SW 2-3 SW 2-4
ON ON
OFF OFF
ON OFF
OFF ON