Control Reference Guide - Panasonic SHWL40EG Bedienungsanleitung

This symbol indicates
separate collection of waste
electrical and electronic
equipment.
More detailed information is
contained in "Operating
Instructions <Full version>".
Declaration of Conformity (DoC)
Hereby, "Panasonic Corporation" declares that this product is
in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
Customers can download a copy of the original DoC to our
R&TTE products from our DoC server:
http://www.doc.panasonic.de
Contact to Authorised Representative:
Panasonic Marketing Europe GmbH, Panasonic Testing
Centre, Winsbergring 15, 22525 Hamburg, Germany
This product is in compliance with the radio standards of the
following countries.
GB, DE, AT, BE, DK, SE, FR, IT, ES, NL, FI, GR, PT, PL, HU,
CZ, SK, EE, LV, LT, SI, BG, RO, MT, CY, IE, LU, HR, NO, CH,
IS, LI, TR
The WLAN feature of this product shall exclusively be used
inside buildings.
This product on purpose to connect to access point of
2.4 GHz or 5 GHz WLAN.
Product Identification Marking is located on the bottom of the
unit.

Control reference guide

Top
1
1
1
1
1
1
Rear
1 Power indicator
The unit is in the standby condition when the AC
adaptor is connected. The primary circuit is always
"live" as long as the AC adaptor is connected to an
electrical outlet.
2 5 G indicator
3 2.4 G indicator
4 LINK / Wireless LAN Signal Strength
2
(Strong) indicator*
5 LAN1 / Wireless LAN Signal Strength
(Normal) indicator* 2
6 LAN2 / Wireless LAN Signal Strength
2
(Weak) indicator*
7 DC IN terminal
8 LAN2 terminal
9 LAN1 terminal
10 RESET button
Use a paper clip or similar to press this button
when this unit is not working correctly, for
example.
11 LINK / LEVEL button
The function varies depending on the length of
time it is pressed or pressed and held.
≥Press and hold for about 3 to 6 seconds to
connect to a 2.4 GHz network.
≥Press and hold for more than about 6 seconds to
connect to a 5 GHz network.
≥Press for a very short time (less than about
1 second) to check the strengh of signal
received from the wireless broadband router.
*1 Lights up or flashes when the corresponding
function is in operation.
*2 Indicates the wireless LAN signal strength of the
wireless broadband router.
≥ When this unit is not working correctly, disconnect
and reconnect the AC adaptor first.
If the problem persists, press and hold the [RESET]
button with a paper clip or similar object for at least
5 seconds until the LINK indicator lights up, and then
release the button.
3
TQBM0010