Operation; Switching On And Off; Select Oscillation Speed; Maintenance And Cleaning - Parkside IAN 282489 Originalbetriebsanleitung

Operation

Switching on and off
Switching on:
♦ Push the ON/OFF switch
the appliance on.
The LED work light
ance is switched on to light up the working area
in low light conditions.
NOTE
► The LED work light
without dust extraction unit
Switching off:
♦ Push the ON/OFF switch
switch the appliance off.

Select oscillation speed

♦ Use the speed adjustment wheel
required oscillation speed.
Stage 1: low oscillation speed
Stage 6: high oscillation speed
NOTE
► The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests.

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
■ Do not use any sharp objects to clean the ap-
pliance. Never permit liquids to enter inside the
appliance. This can damage the appliance.
■ Clean the appliance regularly, preferably imme-
diately after completion of the work.
■ Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
■ A vacuum cleaner is required for thorough
cleaning of the appliance.
■ Ventilation openings must never be obstructed.
PAMFW 12 B1
forwards to switch
lights up when the appli-
may only be used
.
backwards to
to set the
■ Remove any adhering swarf with a brush.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
climate is cool and dry.
NOTE
► Replacement parts not listed (such as carbon
brushes, switches and replacement batteries)
can be ordered via our service hotline.
Kompernass Handels GmbH
warranty
Dear Customer,
This appliance has a 3-year warranty valid from
the date of purchase. If this product has any faults,
you, the buyer, have certain statutory rights. Your
statutory rights are not restricted in any way by the
warranty described below.

Warranty conditions

The validity period of the warranty starts from the
date of purchase. Please keep your original receipt
in a safe place. This document will be required as
proof of purchase.
If any material or production fault occurs within
three years of the date of purchase of the product,
we will either repair or replace the product for you
at our discretion. This warranty service is depend-
ent on you presenting the defective appliance and
the proof of purchase (receipt) and a short written
description of the fault and its time of occurrence.
If the defect is covered by the warranty, your product
will either be repaired or replaced by us. The repair
or replacement of a product does not signify the
beginning of a new warranty period.
GB │ MT │
21 ■