akkut Safe 8 Compact Bedienungsanleitung Seite 5

Replacing the charging cable
Step 1 Squeeze the plastic part of the charging cable grommet (13) on the inside of the locker and pull the plastic
part out.
Step 2 Loosen the cable ties that secure the cables to the USB-Hub (12).
Step 3 Unplug the defective cable and pull it through the charging cable grommet (13) to remove it.
Step 4 Thread the replacement cable through the charging cable grommet (13), plug it into the USB-Hub (12), and
clamp the plastic part of the charging cable grommet (13) back into place on the inside of the locker.
Troubleshooting
There are questions regarding the installation of the charging locker (1)
Where can the charging locker (1) be installed?
Charging locker (1) is not supplied with power
Charging locker (1) is not connected to the power grid
The power cable (22) is not connected to the charging
locker
Devices are not charging
Charging locker (1) is not supplied with power
Charging cable (3) is not compatible with devices
The device is already fully charged
Charging cable (3) must be replaced
The lighting/display (5) does not work
Charging locker (1) is not connected to the power grid
The charging locker (1) is not used for a longer period of time
Charging locker (1) itself is not used
Forgotten password / PIN
The PIN of a single compartment has been forgotten
The administrator password was forgotten
The voice output of the charging locker (1) is too loud
The voice output is too loud
Power cut
How can I open the compartments in case of a power cut?
An unknown error has occurred
Our customer service team is available to assist with any further enquiries or problems!
Contact details can be found on the back.
In principle, the charging locker (1) can be mounted anywhere
on a flat surface. The „Installation" chapter in this manual
provides assistance.
Check if the power cable (22) is properly connected to the
power supply (socket).
Check if the power cable (22) is properly connected to the
power cable connector (15).
See previous points.
The built-in charging cables (3) feature the most common
connectors, which are compatible with 99% of all
smartphones and therefore charge them.
When the battery of a device is 100% charged, the
smartphone or tablet automatically shuts down to
prevent overheating.
See section "Replacing the charging cable".
See point "Charging locker (1) is not supplied with power".
Disconnect the charging locker (1) from the power supply.
For security reasons, if the PIN is entered incorrectly six times,
the compartment will be locked and must be unlocked by the
administrator. To reset the PIN, follow the instructions in the
„Change password" section.
To reset your password, follow the instructions in the
„Changing password" section.
Unlock the right side of the charging locker (1) using the
key (21) and adjust the control (11) at the top by turning it.
In the event of a power outage, you can use the key to unlock
the locker on the right and manually open each compartment
on the left using the small silver lever. (Attention: PINs must be
reset afterward – as they are saved.) Tip: Confirm that the
smartphone belongs to the person by having the phone number
read out and then calling the phone in the locked compartment.
5