Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Additional Handle; Fitting A Tool; Removing A Tool - Parkside PAH 1300 A1 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PAH 1300 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Installation

Additional handle:

You can position the additional handle
you wish.
Undo the knurled nut
Swing the additional handle
appliance axis or 180° forward or backward
into the desired position (see foldout page).
Retighten the knurled nut

Fitting a tool:

Pull the locking sleeve
Insert the tool with a rotating movement in the
tool holder
until it clicks into itself.
Release the locking sleeve
This locks the holder.
Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.

Removing a tool:

Pull the locking sleeve
the tool out of the tool holder

Adjust chisel position:

You can adjust the flat chisel
working position.
Place the flat chisel
Push the chisel adjustment ring
turn with the chisel adjustment ring
chisel
to the required position.
Release the chisel adjustment ring
him until it clicks.
PAH 1300 A1
as
.
around the
.
backwards.
.
backwards and pull
.
in optimal
into the tool holder
.
forward and
the flat
and turn

Operation

Switching on and off
During operation, you can choose between instan-
taneous and continuous operation.
Switching to instantaneous operation:
Press the ON/OFF switch
Switching off instantaneous operation:
Release the ON/OFF switch
Switching to continuous operation:
Press the ON/OFF switch
position with the locking switch
Switching off continuous operation:
Press the ON/OFF switch
again.

Maintenance and cleaning

WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work
on the appliance.
The appliance must always be kept clean, dry
and free from oil or grease.
Use a soft, dry cloth to clean the housing.
Clean the tool holder
Before fitting a tool into the tool holder
grease it lightly.
WARNING!
If the replacement of the supply cord is nec-
essary, this has to be done by the manufac-
turer or his agent in order to avoid a safety
hazard.
.
.
and lock it in this
.
and release it
regularly:
,
GB │ MT
 13

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 277023

Inhaltsverzeichnis