Original Accessories/Auxiliary Equipment; Operation; Switching On And Off; Adjusting The Rotational Speed - Parkside IAN 270700 Originalbetriebsanleitung

■ Only use milling bits of the correct shaft diameter
and which are suitable for the power tool
speed.
■
Fix and secure the workpiece using clamps
or other methods to a stable base. If you hold
the workpiece in your hands or against your
body only it will remain unstable, and this can
result in loss of control.
Original accessories/auxiliary
equipment
■ Use only the accessories and additional
equipment that are specified in the operat-
ing instructions and are compatible with the
appliance.

Operation

Never use the appliance for other purposes and
only with original parts/accessories. Using attach-
ments or accessory tools other than those recom-
mended in the operating instructions can lead to
a risk of injury. Only use completely unrolled and
undamaged extension cables with a capacity of
at least 5 A.
WARNING!
► Do not use this power tool to make cuts in the
vicinity of installations or openings containing
live electrical cables or in walls in which live
electrical cables are possibly hidden. The
bit can conduct electrical current into the
tool which can result in the danger of an
electrical shock for the operator.
–
Trigger the circuit breakers or remove the
fuse in order to ensure that the affected
power circuit is isolated.
WARNING!
► Always hold the tool by the plastic housing
and always wear protective goggles when
working with the tool.
PSFS 250 A1
Switching on and off
Switching on:
♦ Press the ON/OFF switch
Switching off:
♦ Release the ON/OFF switch

Adjusting the rotational speed

♦ Turn the speed control
the speed.
♦ Turn the speed control
the speed.

Changing tools

NOTE
► Use only multitool milling cutter accessories
with a shaft diameter of ø 4.8 mm.
♦ Press and hold the spindle lock button
♦ Loosen the tensioning nut using the
ended spanner by turning it anticlockwise.
♦ Change the tool.
♦ Block the spindle lock, and tighten the tensioning
nut with the aid of the open-ended spanner
.
Bits:
The bits supplied can be used for the following
applications:
Multipurpose milling cutter (HSS)
Suitable for: wood, chipboard, plastic, aluminium
and sheet metal
Slotting cutter (HSS)
Suitable for: wood, chipboard, plastic
Abrasive belt :
Suitable for: sanding wood
NOTE
► If you are intending to cut wall tiles and/or
process sheet metal/metal alloys, please use
appropriate accessories from your specialist
supplier.
.
.
to the right to increase
to the left to decrease
.
open-
:
:
GB
5