Extracting Dust; Using The Tool In Continuous Operation; Maintenance And Cleaning; Disposal - Parkside IAN 270700 Originalbetriebsanleitung

♦ Undo the wing screw
and push the guide rod on the circular/parallel
cutting attachment
on the bottom of the baseplate
centring point is facing downwards.
♦ Insert the centring point into the centre of the
circle.
♦ Adjust the circular/parallel cutting attachment
spacing so that the bit can be inserted into the
guide hole at the edge of the circle.
♦ Lock the baseplate
screws .
♦ Switch the tool on by pressing the ON/OFF
switch and holding it down.
♦ Push the tool slowly forwards.

Extracting dust

■ The tool is fitted with an extraction nozzle
for dust extraction.
♦ Insert the adapter
♦ Connect a vacuum cleaner to the adapter

Using the tool in continuous operation

Lock the ON/OFF switch
♦ Press the ON/OFF switch
♦ Now press the locking switch
the ON/OFF switch
Unlocking the ON/OFF switch
♦ Press the ON/OFF switch
PSFS 250 A1
on the baseplate
through the two recesses
so that the
by tightening the wing
into the extraction nozzle
:
.
and release
.
:
and release it.

Maintenance and cleaning

,
WARNING! RISK OF INJURY!
Always switch the appliance off
before carrying out any work on it.
The appliance is maintenance-free.
■ Always clean the appliance directly after finishing
work.
■ Use a dry cloth to clean the housing. Under
no circumstances should you use detergents,
solvents or abrasive cleaners.
■ Ensure ventilation openings are always free of
obstructions.
■ Remove any adhering swarf with a brush.
NOTE
► Spare parts which are not listed (e.g.
► carbon brushes, switches, can be ordered
using our service hotline.

Disposal

.
The packaging is made from environmen-
.
tally friendly material and can be disposed
of at your local recycling plant.
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU requires that
worn-out power tools be collected separately and
recycled in an environmentally compatible manner.
GB
7