Schedule Setting; Record / Detection / Alarm In / Alarm Out / Push Video / Buzzer; Regular Report - elv MODELL 3 Bedienungsanleitung

6.5 SCHEDULE SETTING

6.5.1 RECORD / DETECTION / ALARM IN / ALARM OUT / PUSH VIDEO / BUZZER

Select the timer type you want to configure (RECORD / DETECTION / ALARM IN / ALARM OUT / PUSH VIDEO /
BUZZER), choose "ON" to enable the timer, and select the day and time for this function.
RECORD
DETECTION
ALARM IN
ALARM OUT
PUSH VIDEO
BUZZER

REGULAR REPORT

AUTO BACKUP
REGULAR REBOOT
EXIT
X axis 0 ~ 24 hours. Each time bar is 30 minutes.
Y axis Monday ~ Sunday.
6.5.2 REGULAR REPORT
This function is used to send event reports to the specified E-mail address. Users could configure up to 5 profiles
to receive different reports about specific channels at different time.
Note: This function is available only when a hard disk is installed, and the DVR is connected to Internet.
RECORD
DETECTION
ALARM IN
ALARM OUT
PUSH VIDEO
BUZZER
REGULAR REPORT
AUTO BACKUP
REGULAR REBOOT
EXIT
Step1: Select the profile you want to configure, and enable it.
Step2: Select the frequency to send reports in "PERIOD": DAILY / MONTH / WEEK.
Step3: When MONTH or WEEK is selected, select which date or day from "DAY OF MONTH" or "DAY OF WEEK".
Step4: Then, select which time you want to receive reports, which channel(s) you want to see, and which event
type(s) you want to see (ALARM / MANUAL / MOTION / SYSTEM / TIMER / INFLOW / OUTFLOW /
VIRTUAL FENCE / ONEWAY / SCENE CHANGE).
Step5: Configure the email address to receive reports.
Note: The sender E-mail should be configured in "ADVANCED CONFIG"  "NETWORK"  "E-MAIL" for
this function to work properly. For details, please refer to "E-MAIL" at page 36.
SCHEDULE SETTING
RECORD TIMER
0 2 4
SUN
MON
TUE
WED
THU
FRI
SAT
SCHEDULE SETTING
PROFILE
ACTIVE
PERIOD
DAY OF MONTH
HOUR
CHANNEL
EVENT TYPE
E-MAIL
6 8 10 12 14

1
ON

DAILY
1

1

CH1

MOTION
SETUP
50
ON
16 18 20 22 24
MAIN MENU