Herunterladen Diese Seite drucken

elv MODELL 3 Bedienungsanleitung Seite 23

Hd-cctv-dvr 1080p-videoaufnahme

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 264
/
/
/
/
/
/
/
In the split view
Click
on the channel status bar to display the panel as follows:
/
/
/
How to set a preset point:
Step1:
Camera Menu
Enter
Up / Down / Left / Right
Iris + / Iris -
Zoom in / out max
Zoom in / out
Focus near / far
Auto mode
Preset point
Auto tracking
Manual Focus
Auto Focus
Up / Down / Left / Right
/
/
Digital zoom in / out
Focus near / far
Preset point
Click to enter the camera main menu.
For details about each camera menu, please refer to its own user
manual.
Click to confirm your selection / enter the menu.
Click the arrow keys ( /  /  / ) to more the camera lens up /
down / left /right.
This two buttons are designed for the PTZ camera which uses
Pelco-D to control. To know the actions after clicking Iris + and Iris -,
please refer to the camera's user manual.
Click to zoom in on the image to the largest / zoom out on the image
to its original size.
Click to zoom in / out the image.
Click to adjust the focus of the image.
Click to activate the auto function.
Before using it, you need to assign a specific function that will be
enabled when "
" is clicked. For details, please refer to the user
manual of the camera.
Click to enter the PTZ preset point you want to see.
Click to start auto tracking when your speed dome camera supports
this function.
This function is used to memorize the focus parameters you've made
after you use
/
length and focus. The next time when you move to the same focal
length, the camera will use the parameters as the ones for Auto
Focus.
Click to automatically adjust the focus of the camera.
Click to move your selection up / down / left / right, or
change settings.
Click to zoom in / out the camera image digitally.
Click to adjust the focus of the image.
Click to display the preset point panel for preset point
viewing or setting. For details, please refer to the section
below.
Step2: Click
or
to the proper ratio you need, and
click
/
/
want to configure as a preset point.
Step3: Click the numbering you want to configure for this
point, and wait till you see
appearing and disappearing on the DVR status bar.
Step4: Repeat from Step1 again to set other points if
needed, or click
selection panel.
17
FREQUENTLY-USED FUNCTIONS
/
/
to manually adjust the focal
to move to the point you
/
(command sending)
to return to the preset point

Werbung

loading