External Device Connection; Dvr Power On - elv MODELL 3 Bedienungsanleitung

STEP 3: Twist the RS485-A and RS485-B wires of the RJ11 cable and the speed dome camera together.
Twist the RS485-A (red) and RS485-B (green) wires of the RJ11 cable to the RS485-A and RS485-B
wires of the speed dome camera. To protect the naked wires, use the insulation tape to cover on the
twisted wires.
STEP 4: Connect the other end of RS485-A and RS485-B wires to your DVR.
Find the RS485-A and RS485-B pins on the DVR rear panel, and connect the camera to the
corresponding pins of the DVR.
STEP 5: Set the camera at the DVR side.
Right click to show the main menu in the live view, and go to "
to set the camera.
a) Select the device to "PTZ".
b) Set the ID to the value the same as the one set in the camera.
c) Select the protocol to "P-P", "P-D", "S-T" or "S-E".
Note: "P-P" and "P-D" are protocols used Pelco, and "S-T" and "S-E" are protocols used by Samsung.
d) Set the baud rate to the value the same as the one set in the camera.
e) Set the interface to "RS485".
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
DCCS
IVS
NOTIFY
EXIT

2.3 External Device Connection

Some DVR models support external device connection with RS485 and alarm I/O ports, allowing users to connect
control devices such as a keyboard controller, or connect alarm devices such as a magnetic contact or buzzer.
Check the user manual of your external device to know which pin(s) should be used, and connect it to the
corresponding pins on the DVR rear panel.

2.4 DVR Power On

This device should be operated only with the type of power source indicated on the manufacturer's label. Connect
the indicated AC power cord to the power adapter, and plug into an electrical outlet.
If your device has a power switch on the rear panel, turn it to "—". The power LED will be on. If your device doesn't
have a power switch on its rear panel, the power is on once the power source is connected.
Note: Before the DVR is powered on, make sure (1) the cameras are connected and power-supplied for
the detection of the camera video system to be correct, and (2) a HDMI monitor is connected to
the DVR for correct video output detection.
Note: To ensure that your DVR works constantly and properly, it's recommended to use an UPS,
Uninterruptible Power Supply (Optional), for continuously operation.
ADVANCED CONFIG
CH1 CH2 CH3 CH4
DEVICE
ID
PROTOCOL
RATE
INTERFACE
" (ADVANCED CONFIG)  "DEVICES"

PTZ
000

P-P

2400

RS485
7
CONNECTION AND SETUP